Revestimentos comestíveis na aplicação em melancia e melão: adição do adjunto óleo de buriti e vida de prateleira

Abstract

The objective of this study was to evaluate the potential of cassava starch and pectin-based edible coatings with and without addition of buriti oil for application in minimally processed watermelon and melon, aiming to extend the shelf life of these products. The quality of the buriti oil added to the edible coatings was confirmed by physicochemical parameters; Density: 1021 kgm-3; Acidity index in oleic acid: 1.59%; Peroxide index: 6.20 meqKg-1 and kinematic viscosity: 41.3 mm²s-1. The characterization of the main fatty acids present in the buriti oil was performed by spectroscopic methods of Proton Nuclear Magnetic Resonance (1H-NMR) and Fourier Transform Infrared Spectroscopy (FTIR). Oleic acid (78%) had the major percent composition in the buriti oil. The edible coatings were prepared with the concentration of 3% cassava starch or 3% pectin, 1% glycerol or 1% buriti oil, 2.5% gelatin, 0.5% citric acid and 0.5% ascorbic acid, the minimally processed fruits were coated using the immersion technique. The coated fruits were analyzed for pH, total soluble solids, titratable acidity and microbial counts over 10 days of storage. The pH of the coated fruits varied between 5.35 and 5.76 for melon and 4.52 and 5.49 for watermelon over the storage time, respectively. The total soluble solids contents of minimally processed watermelon (7.6-9.6 ° Brix) and melon (7.2-8.63 ° Brix) remained constant for all evaluated coatings. The titratable acidity of watermelon and melon ranged from 0.11 to 0.20% and from 0.06 to 0.14% in citric acid. The edible coatings presented an efficient barrier for vapor permeability, being the starch-based film provided a lower average loss of watermelon mass (2.32%) and starch/oil coating for melon (3.39%). The aerobic and mesophilic microbial population was increasing over the storage period in all coatings and control in both fruits. At the end of the 10 days of storage, the watermelon had a bacterial growth of about 9 log UFCmL-1, the same value for mold and yeast population. The starch and pectin/oil coatings provided a lower bacterial population of approximately 7.8 log UFCmL-1. The melon presented higher values of bacterial population in comparison with the watermelon in the starch and control coating; 10.15 and 9.7 log UFCmL-1, respectively. The mold and yeast counts were also higher in the starch and oil coatings, approximately 9 log UFCmL-1. It is concluded that the buriti oil in this work didn’t present antimicrobial activity in the edible coatings present in the fruits. The edible coatings starch and pectin provided the watermelon suitable conditions for consumption until the eighth day after processing. However, for the melon, only pectin and pectin/oil coating ensured microbiological stability for consumption up to the fourth day of storage.